Empire Comfort Systems DVP48FP9(1 Manuel du propriétaire télécharger pdf (Page 76)

28649-2-0811Page 76

CAUTION: ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE WITH ALL LOCAL,

CITY AND STATE BUILDING CODES. BEFORE MAKING THE ELECTRICAL CONNECTION, MAKE SURE THAT MAIN POWER SUP-

PLY IS DISCONNECTED. THE APPLIANCE, WHEN INSTALLED, MUST BE ELECTRICALLY GROUNDED IN ACCORDANCE WITH

LOCAL CODES OR, IN THE ABSENCE OF LOCAL CODES, WITH THE NATIONAL ELECTRICAL CODE ANSI/NFPA 70 (LATEST

EDITION).

A factory installed junction box is located on the lower right side of the

replace. Wiring must be fed to the junction box and attached to the

receptacle that is provided. Leave approximately 6" of wire in the junction

box for connection.

Attach black wire to one side of the receptacle and white wire to opposite

side of receptacle. The ground wire should be attached to the green

(ground) screw.

Install the receptacle into the junction box. Attach cover plate.

1. Using gloves, unpack liner components and check for damaged

or missing components.

2. Lower bottom louver and remove upper louver on replace.

3. Remove glass frame assembly from replace.

4. Remove rear logs from burner assembly.

5. Place brick panel (rear) against rear wall in replace.

Note: The top edge will have a half-moon cutout relief to match up

with the rear ue vent hole.

6. While holding nished edge on brick panel (side), place brick

panel (sides) against side walls in replace. Move side panels

rearward until the back edge meets the rear brick panel. Slide

side brick panels down so they rest on rebox bottom.

7. Align grout lines on top brick panel with the grout lines on the

side brick panels. Place the top brick panel into brick panel

holder. With needle-nose pliers, carefully bend hold-down tabs

on brick panel holder over the edges of the top brick panel.

The hold-down tabs will securely hold the top brick panel in

place.

8. Replace rear logs onto burner assembly. (Refer to log

placement, page 45.)

9. Attach glass frame assembly onto replace.

10. Raise bottom louver and replace top louver onto replace.

11. Installation of optional brick liner is complete.

*Note: For intermittent pilot models, refer to wiring instructions on page 56.

JUNCTION BOX WIRING INSTALLATION INSTRUCTIONS

OPTIONAL BRICK LINER INSTALLATION INSTRUCTIONS

Figure 94

1 2 ... 71 72 73 74 75 76 77 78 79 80

Pas de commentaire

Empire Comfort Systems DVP48FP9(1 Manuel du propriétaire Page 76